Skip to content
ImprovementCalcIndependent cost estimates for US homeowners

Heating & Cooling

Heating & Cooling cost calculators

  • AC Replacement Cost Calculator

    Price a new central air conditioner by home size, climate, efficiency and ductwork.

    Typical cost: $5,100 – $8,300 · 3-ton, standard efficiency

  • Furnace Replacement Cost Calculator

    Price a new gas, electric, propane or oil furnace by home size, climate and efficiency.

    Typical cost: $3,800 – $8,500 · 80,000 BTU gas, standard

  • Heat Pump Cost Calculator

    Price an air-source or geothermal heat pump by home size, climate, efficiency and ductwork.

    Typical cost: $7,100 – $12,300 · 3-ton air-source

Replacing a central air conditioner typically costs $5,100 – $8,300 for a 3-ton standard system, a gas furnace $3,800 – $8,500, and a ducted air-source heat pump $7,100 – $12,300. Smaller jobs, from a new thermostat to duct cleaning, run a few hundred dollars. Start with the AC replacement cost calculator, the furnace calculator or the heat pump calculator.

Heating and cooling costs at a glance

ProjectTypical cost (national)What drives the priceCalculator
Central AC replacement$5,100 – $8,300 (3-ton, standard efficiency)Size in tons, efficiency (SEER2), ductwork conditionAC replacement calculator
Furnace replacement$3,800 – $8,500 (80,000 BTU gas, standard)Fuel, size in BTU, efficiency (AFUE), ventingFurnace calculator
Heat pump$7,100 – $12,300 (3-ton air-source); geothermal much moreType, size, efficiency, ductwork, electrical upgradesHeat pump calculator
Boiler replacement$3,000 – $8,500Fuel, size, efficiency, piping changesComing soon
Ductless mini-split$3,000 – $4,900 (one zone); up to about $14,000 (multi-zone)Number of indoor units, capacity, line lengthComing soon
Ductwork replacement$1,400 – $6,000 ($25 – $55 per linear ft)Length of runs, attic or crawl space access, insulationComing soon
Radiant floor heating$2,000 – $6,000; electric $8 – $15 per sq ftElectric vs hydronic, floor area, new boilerComing soon
Air duct cleaning$300 – $700Number of vents, home size, accessComing soon
Baseboard heaters$150 – $400 per electric heater; $420 – $1,526 typical jobElectric vs hydronic, number of heaters, new circuitsComing soon
Swamp cooler$1,500 – $3,500Size, roof or ground mount, ductingComing soon
Thermostats and small jobs$85 – $300 (programmable); $185 – $600 (smart)Thermostat type, new wiringComing soon
Window AC installation$140 – $525 (about $313 typical)Unit size, window type, new circuitComing soon
Installed prices including labor and equipment, national averages. AC, furnace and heat pump ranges come from our calculators and include a $50 to $300 permit.

Which heating or cooling project do you need?

Repair or replace?

Most AC and heat pump repairs cost $150 to $700, and most furnace repairs $100 to $1,200. A repair is usually worth it on a system under about 10 years old. Once a system is 12 to 15 years old, a big repair, like a compressor ($600 to $3,000) or a heat exchanger ($500 to $3,500), often makes replacement the better buy. A common rule of thumb: multiply the repair price by the system’s age. If the answer is more than the cost of a new system, replace it.

Getting the size right

Contractors often size by square feet, but a proper Manual J load calculation looks at your insulation, windows, ceiling height and climate. An oversized AC cools quickly but leaves the house clammy and wears out sooner; an undersized one runs nonstop. Our calculators use a rule of thumb to get you in the right price range, then you should ask every bidder how they sized the system.

Heat pump, or furnace and AC?

Your situationUsually the best fit
Mild or mixed climate, ducts in good shapeAir-source heat pump (heats and cools in one system)
Cold northern climate, cheap natural gasGas furnace plus AC, or a heat pump with the furnace kept as backup
Heating with oil, propane or electric baseboardHeat pump; these homes usually save the most
No ductworkDuctless mini-splits or a boiler, not new ducts
Large lot, staying 15+ yearsGeothermal heat pump, if the budget allows

Newer cold-climate heat pumps can heat homes in New England and the upper Midwest, and the US Department of Energy reports they can cut household energy use by up to 40%. They cost more up front, and cold-climate homes may still need backup heat on the coldest nights.

Efficiency ratings and the 2023 federal minimums

SEER2 measures cooling efficiency, HSPF2 heat pump heating efficiency, and AFUE the share of fuel a furnace turns into heat. Since January 1, 2023, new central air conditioners must reach at least 13.4 SEER2 in northern states and 14.3 SEER2 (for most home sizes) in the Southeast and Southwest. Split heat pumps must reach 14.3 SEER2 and 7.5 HSPF2 everywhere.

RatingWhat it measuresStandardHigh efficiency
SEER2Cooling efficiency (AC and heat pumps)13.4 – 1516 – 20+
HSPF2Heat pump heating efficiency7.5 – 88.5 – 10+
AFUEFurnace fuel efficiency80%95% – 98.5%

Choosing a heating and cooling system

SystemTypical installed costTypical lifespanBest for
Central AC (plus existing furnace)$5,100 – $8,300 (3-ton)15 – 20 yearsHomes with ducts and a working furnace
Gas furnace$3,800 – $8,50015 – 20 yearsCold climates with gas service
Air-source heat pump$7,100 – $12,300 (3-ton)15 years or soMild and mixed climates; replacing oil, propane or electric heat
Geothermal heat pump$15,000 – $35,00020+ years indoors; ground loop much longerLong-term owners with space for a loop
Ductless mini-split$3,000 – $14,00015 – 20 yearsAdditions, homes without ducts, single rooms
Boiler$3,000 – $8,50015 – 30 yearsHomes with radiators or radiant floors
Lifespans are typical ranges and depend on maintenance and climate.

Common heating and cooling mistakes

  • Sizing by square feet alone. Ask every contractor for a Manual J load calculation. A system that is too big costs more and controls humidity poorly.
  • Replacing the outdoor unit without matching the indoor coil. A mismatched coil can cut efficiency and void the warranty. A real replacement quote includes both.
  • Ignoring leaky ducts. A new system pushing air through leaky or crushed ducts won’t deliver its rated efficiency. Have the ducts checked and sealed at the same time.
  • Counting on federal tax credits. The federal 25C energy-efficiency credit ended for equipment installed after December 31, 2025. Check state and utility rebates instead.

Hiring an HVAC contractor

Most states license HVAC or mechanical contractors, and handling refrigerant requires EPA Section 608 certification. Gas line and venting work also needs a licensed pro. Ask for the license number, proof of insurance, and the technician’s refrigerant certification.

A permit is usually required to replace a furnace, AC or heat pump; it typically costs $50 to $300, and the contractor normally pulls it. Get at least three written quotes. A good quote names the brand and model numbers for every piece of equipment, the size and efficiency ratings, what happens to the ductwork, the thermostat, the permit, haul-away, and both the manufacturer’s and the installer’s labor warranty.

Safety: furnaces, boilers and gas lines can leak carbon monoxide or gas if installed wrong. Leave gas, venting, refrigerant and high-voltage electrical work to licensed pros, and make sure you have working carbon monoxide alarms.

HVAC prices vary by region because of labor rates, codes and demand. Pacific and New England states often pay 20% to 25% above the national average. Each ImprovementCalc calculator adjusts its estimate for your zip code.

Related costs: Insulation, Electrical, Solar and Plumbing & Water Heaters.

Get local HVAC quotes

Price your system first, then compare quotes. Use the AC replacement cost calculator or the heat pump calculator to get an estimate and request up to three free quotes, with no obligation.

Heating and cooling FAQs

How long do HVAC systems last?

Central air conditioners and gas furnaces typically last 15 to 20 years, air-source heat pumps around 15 years, and boilers 15 to 30 years. Regular maintenance makes a big difference.

Should I replace my AC and furnace at the same time?

Often, yes, if both are over 12 to 15 years old. You pay for one installation, the indoor coil and blower are matched, and you may be able to switch to a heat pump instead of buying two systems.

What size AC or heat pump do I need?

A rough rule is one ton of cooling for every 450 to 600 sq ft, depending on climate. The right size depends on insulation, windows and layout, so ask for a Manual J load calculation.

Are there tax credits for HVAC in 2026?

Not federal ones. The federal energy-efficiency tax credit ended for equipment installed after December 31, 2025. Many states and utilities still offer rebates for heat pumps and high-efficiency equipment.

What does an HVAC tune-up cost?

An annual furnace tune-up usually costs about $70 to $300. Yearly maintenance helps catch small problems before they become expensive repairs.